Chapter 6. Configuring DTE Options
For IDLE WHEN OFF option: In SW56 mode, TR off causes the DSU to go On
Hook (Idle). The unit also does not dial out if TR is off. In dedicated mode, the
DSU goes into DTE command mode when TR goes off. When TR goes on, if the
DSU does not receive a command in the number of seconds set in S40, the DSU
goes into data mode.
SR Options
The SR OPTIONS menu is used to select the operating mode for the data
set ready (SR) lead. Press Shift + A to activate the SR OPTIONS sub-
menu. The factory default setting is OFF TEST ONLY (shown in Figure 6-
11).
1=LOCAL
3=CONFIG
2=REMOTE ENTER ADDRESS
6-14
1=NETWORK OPT.
2=DTE OPTIONS
3=TEST OPTIONS
4=DIAL OPTIONS
5=MANUAL
Figure 6-11. Setting SR Options
DSU III ARdc User Manual
1=DTE RATE
2=CONNECTOR TYPE
3=DATA FORMAT
4=DTE CMD OPTION
5=TRANSMIT CLOCK
6=CS OPTIONS
7=ANTI-STREAM
8=CD OPTIONS
1=FORCED ON
9=TR OPTIONS
2=OFF OOS ONLY
A=SR OPTIONS
3=OFF LOCD ONLY
4=OFF TEST ONLY
5=OFF TEST +OOS
6=OFF TEST +LOCD
61200270L1-1