Configuration; Table 2-3. Pin Assignments For Primary V.35 Connector - ADTRAN DSU III ARdc User Manual

Chapter 2. Installation

Table 2-3. Pin Assignments for Primary V.35 Connector

Pin
A
B
C
D
E
F
H
J
L
N
R
T
V
X
P
S
Y
AA
U
W
NN

CONFIGURATION

The DSU III ARdc contains four different user profiles (sets of configura-
tions options) that are stored in read only memory. These profiles are
listed in Appendix B "Default Configuration Profiles" on page B-1. The unit is
shipped from the factory with profile 1 (default configuration) loaded into
the nonvolatile configuration memory. If profile 1 matches the desired
system requirements, then no additional configuration is required to put
the unit into service. If profile 1 does not match the desired system
2-4
CCITT
101 Protective Ground (PG)
102 Signal Ground (SG)
105 Request to Send (RS)
106 Clear to Send (CS)
107 Data Set Ready (SR)
109 Received Line Signal Detector (CD)
- Data Terminal Ready (TR)
- Ring Indicator (RI)
- Local Loopback (LL)
- Remote Loopback (RL)
104 Received Data (RD-A)
104 Received Data (RD-B)
115 Receiver Signal Element Timing (SCR-A)
115 Receiver Signal Element Timing (SCR-B)
103 Transmitted Data (SD-A)
103 Transmitted Data (SD-B)
114 Transmitter Signal Element Timing (SCT-A)
114 Transmitter Signal Element Timing (SCT-B)
113 External TX Signal Element (SCX-A)
113 External TX Signal Element (SCX-B)
- Test Indicator (TI)
DSU III ARdc User Manual
Description
61200270L1-1