Chapter 5. Configuring Network Options
1=LOCAL
3=CONFIG
2=REMOTE ENTER ADDRESS 3=TEST OPTIONS
The default factory setting is AUTO. When configured to AUTO, the DSU
will automatically attempt to adapt to the loop rate. If the loop rate is
known, select the rate from the menu. The various loop rates and format
selections are listed in Figure 5-1 with the equivalent AT commands that
perform the same configuration functions.
5-2
1=NETWORK OPT.
2=DTE OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND
Figure 5-1. Setting Loop Rate Options
Table 5-1. Loop Rate Commands
Front Panel
1=AUTO
2=2.4K
3=4.8K
4=9.6K
5=19.2K
6=38.4K
7=56K
8=64K clear channel
DSU III ARdc User Manual
1=LOOP RATE
2=NETWORK ADDR
3=REMOTE CONFIG.
4=NETWORK TYPE
5=CLOCK SOURCE
AT Command
%B0
%B1
%B2
%B3
%B4
%B5
%B6
%B7
1=AUTO
2=2.4K
3=4.8K
4=9.6K
5=19.2K
6=38.4K
7=56K
8=64K
61200270L1-1