Transmit Clock
The TRANSMIT CLOCK option is used to select the source of the clock
used to transfer data from the DTE to the DSU III ARdc. Figure 6-6 shows
the menu path used to set the TRANSMIT CLOCK option.
1=LOCAL
3=CONFIG
2=REMOTE
Table 6-4 shows the AT commands used to set the Transmit Clock option.
1=NORMAL
2=EXTERNAL
The EXTERNAL clock option is normally used in modem tail circuit
applications. A DSU-to-modem interconnect diagram for this application
is shown in Appendix C "DSU-to-Modem Interconnect" on page C-1.
The EXTERNAL clock option is also recommended when the EIA-232
connector is used for 56 kbps and 64 kbps applications. A special DSU
61200270L1-1
1=NETWORK OPT.
2=DTE OPTIONS
ENTER ADDRESS
3=TEST OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND
Figure 6-6. Transmit Clock Options
Table 6-4. Transmit Clock AT Commands
Front
AT
Panel
Command
&X0
&X1
DSU III ARdc User Manual
Chapter 6. Configuring DTE Options
1=DTE RATE
2=CONNECTOR TYPE
3=DATA FORMAT
4=DTE CMD OPTION
5=TRANSMIT CLOCK
6=CS OPTIONS
7=ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
A=SR OPTIONS
Description
TX clock from DSU selected
ETC clock from DTE selected
1=NORMAL
2=EXTERNAL
6-7