Chapter 6. Configuring DTE Options
DTE Command Option
The DTE COMMAND option is used to enable AT commands from the
DTE, enable V.25 bis SDLC (synchronous data link control) commands,
enable V.25 (bisync and async), or disable all DTE command modes (see
Figure 6-5).
1=LOCAL
3=CONFIG
2=REMOTE
Figure 6-5. Selecting DTE Command Option
When the unit is in DTE CMD OPTION mode (idle in SW56 mode, forced with
TR option, or from escape sequence in AT mode) with AT COMMAND SET or
V.25 SYNC selected, the DTE format is independent of the DATA FORMAT
option. However, if V.25 BSC/ASYNC is selected, the unit will use V.25 BISYNC
(BSC) commands for synchronous data format or V.25 ASYNC commands for
asynchronous data format.
6-6
1=NETWORK OPT.
2=DTE OPTIONS
ENTER ADDRESS
3=TEST OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND
DSU III ARdc User Manual
1=DTE RATE
2=CONNECTOR TYPE
3=DATA FORMAT
1=DISABLED
4=DTE CMD OPTION
2=AT COMMAND SET
3=V.25 SYNC
4=V.25 BSC/ASYNC
5=TRANSMIT CLOCK
6=CS OPTIONS
7=ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
A=SR OPTIONS
61200270L1-1