Table of Contents
Advertisement
Chapter 4
LOCAL AND REMOTE CONFIGURATION
The DSU III ARdc can be configured locally using the front panel or
remotely by establishing communications with another DSU. The front
panel of the local DSU can then be used to configure the remote DSU.
During remote configuration, the DSU III ARdc prompts for the remote
address before continuing to the Configuration (CONFIG) menus.
The Configuration menu consists of a group of five sub-menus relating to
a specific interface or function of the DSU III ARdc that requires setup.
1=Network Opt.
2=DTE Options
3=Test Options
4=Dial Options
5=Manual Command ADTRAN Specific Commands
The DSU III ARdc contains four different user profiles (sets of configura-
tions options) that are stored in read only memory (see Appendix B
"Default Configuration Profiles" on page B-1). The unit is shipped from the
factory with profile number 1 (default configuration) loaded into the cur-
rent (nonvolatile configuration) memory. If profile 1 matches require-
ments for the system, then no additional configuration is required to put
the unit into service. If profile 1 does not match system requirements, it
can be modified or one of the other profiles that more closely matches the
system requirements can be loaded into current memory. When a differ-
ent profile is loaded, or the existing profile is modified, it is stored in the
current (nonvolatile configuration) memory. The DSU III ARdc is then
configured with that profile every time power is turned on or until the
unit is reset.
61200270L1-1
Configuration Overview
Network Interface Parameters
DTE Interface Parameters
Unit Test Options
Unit Dialing Options
DSU III ARdc User Manual
4-1
Advertisement
Table of Contents
Troubleshooting
