Chapter 6. Configuring DTE Options
cable diagram for this application is shown in Appendix D "EIA-232 Con-
nector" on page D-1. Using this option and special cable eliminates data
errors caused by excessive delays in the DTE transmit clock receiver and
transmit data driver.
CS Options
The CS (clear to send) OPTIONS menu is used to select one of five differ-
ent control modes for the CS lead. Figure 6-7 shows the menu path used
to access the CS OPTIONS menu. The default factory setting is FOLLOWS
RS with CS DELAY SHORT.
1=LOCAL
3=CONFIG
2=REMOTE ENTER ADDRESS
If one of the options chosen involves request to send (RS), then the delay
from RS to CS must be selected. Table 6-5 shows the AT Commands used
to set the CS OPTIONS.
6-8
1=NETWORK OPT.
1=DTE RATE
2=CONNECTOR TYPE
2=DTE OPTIONS
3=DATA FORMAT
4=DTE CMD OPTION
5=TRANSMIT CLOCK
6=CS OPTIONS
7=ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
A=SR OPTIONS
3=TEST OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND
Figure 6-7. Selecting CS Options
DSU III ARdc User Manual
1=FORCED ON
1=CS DELAY SHORT
2=FOLLOWS RS
2=CS DELAY LONG
3=FOLLOWS CD
4=FOLOWS RS+CD
1=CS DELAY SHORT
5=OFF WITH LOCD
2=CS DELAY LONG
61200270L1-1