Network Address
A two-digit decimal address can be assigned to each DSU III ARdc. This
addressing capability makes it possible to perform remote configuration
and testing in point-to-point and multi-drop networks. Figure 5-2 shows
the menu path used to change the network address. The factory default
setting is 0.
1=LOCAL
3=CONFIG
2=REMOTE
Table 5-2 shows the AT command used to set the network address.
Front
Panel
XX (Decimal)
Remote Configuration
This option sets up the DSU III ARdc to accept or reject remote configura-
tion commands. Figure 5-3 shows the menu path for enabling/
disabling remote configuration. The factory default setting is
ENABLED.
61200270L1-1
1=NETWORK OPT.
ENTER ADDRESS 2=DTE OPTIONS
3=TEST OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND
Figure 5-2. Setting the Network Address
Table 5-2. Network Address Command
AT
Command
_N=xx
Assigns a two-digit network address
DSU III ARdc User Manual
Chapter 5. Configuring Network Options
1=LOOP RATE
ENTER NETWORK
2=NETWORK ADDR
ADDRESS:0
3=REMOTE CONFIG.
4=NETWORK TYPE
5=CLOCK SOURCE
Description
5-3