Chapter 6. Configuring DTE Options
CD Options
The CD OPTIONS menu is used to select one of three different control
modes for the receive line signal detector (CD) lead. The default factory
setting is NORMAL (see Figure 6-9).
1=LOCAL
3=CONFIG
2=REMOTE
Table 6-8 shows the equivalent AT commands for setting CD options.
1=FORCED ON
2=NORMAL
3=OFF WITH LOCD
6-12
1=NETWORK OPT.
2=DTE OPTIONS
ENTER ADDRESS
3=TEST OPTIONS
4=DIAL OPTIONS
5=MANUAL COMMAND
Figure 6-9. Selecting CD Options
Table 6-8. CD Options AT Commands
Front
AT
Panel
Command
&C0
&C1
&C2
DSU III ARdc User Manual
1=DTE RATE
2=CONNECTOR TYPE
3=DATA FORMAT
4=DTE CMD OPTION
5=TRANSMIT CLOCK
6=CS OPTIONS
7=ANTI-STREAM
8=CD OPTIONS
9=TR OPTIONS
A=SR OPTIONS
Description
On all the time.
On only when data present
on loop.
On except after disconnect
in Switched 56 application.
1=FORCED ON
2=NORMAL
3=OFF WITH LOCD
61200270L1-1