Dte Command Option; Figure 6-5. Selecting Dte Command Option - ADTRAN DSU III AR User Manual

DTE Command Option

The DTE C
the DTE, enable V.25 bis SDLC (Synchronous Data Link Control)
commands, enable V.25 (Bisync and Async), or disable all DTE
command modes (see Figure 6-5).
1= LOCAL
3=CONFIG
2 =REMOTE ENTER
When the unit is in DTE CMD O
with TR option, or from escape sequence in AT mode) with AT C
S
F
use V.25 B
A
61202011L1-1
option is used to enable AT commands from
OMMAND
1= NETWORK OPT.
2= DTE OPTIONS
3= TEST OPTIONS
ADDRESS 4= DIAL OPTIONS
5= MANUAL COM.

Figure 6-5. Selecting DTE Command Option

or V.25 S selected, the DTE format is independent of the D
ET YNC
option. However, if V.25 BSC/A
ORMAT
(BSC) commands for synchronous data format or V.25
ISYNC
commands for asynchronous data format.
SYNC
DSU III AR User Manual
Chapter 6. Configuring DTE Options
1= DTE RATE
2= CONNECTOR TYPE
3= DATA FORMAT
4= DTE CMD OPTION 1= DISABLED
5= TRANSMIT CLOCK 2= AT COMMAND SET
6= CS OPTIONS 3= V.25 SYNC
7= ANTI-STREAM 4= V.25 BSC/ASYNC
8= CD OPTIONS
9= TR OPTIONS
A= SR OPTIONS
B= AUXILIARY PORT
mode (idle in SW56 mode, forced
PTION
is selected, the unit will
SYNC
OMMAND
ATA
6-7