Network Address; Remote Configuration; Network Type; Clock Source - ADTRAN DSU IV ESP User Manual

Chapter 6. Configuring Network Options
equivalent AT commands that perform the same configuration
functions.

Network Address

A two-digit decimal address can be assigned to each DSU IV ESP.
This addressing capability makes it possible to perform remote
configuration and testing in point-to-point and multi-drop
networks. Figure 6-1 on page 6-2 shows the menu path used to
change the network address. The factory default setting is 0.

Remote Configuration

This option sets up the DSU IV ESP to accept or reject remote
configuration commands. The factory default setting is E

Network Type

Select the appropriate network type. The choices are D
AT&T/MCI SW56, and US S
setting is D

Clock Source

The C
IV ESP's internal circuitry. The factory default setting is F
N
When operating on a DDS network, the timing should be F
N
must be set for M
When the DSU IV ESP is set to the Master Clock source, it will
default to its internal oscillators as the clock reference. To enable the
External DTE Port as the reference clock for the circuit, see Chapter
7, Configuring DTE Options on page 7-1 regarding the transmit clock
options.
6-4
.
EDICATED
S option specifies the timing source for the DSU
LOCK OURCE
.
ETWORK
. On a point-to-point private network, one DSU IV ESP
ETWORK
ASTER
DSU IV ESP User Manual
SW56. The factory default
PRINT
, the other set for F
ROM
.
NABLED
,
EDICATED
ROM
ROM
N .
ETWORK
61204011L1-1