Chapter 5. Configuration Overview; Configuration Methods - ADTRAN DSU IV ESP User Manual

Configuration Overview
Chapter 5
The DSU IV ESP contains four different user profiles (sets of
configuration options) stored in read only memory; see
Configuration Profiles on page D-1. The unit is shipped from the
factory with profile number 1 (default configuration) loaded into
the current (nonvolatile configuration) memory. If profile 1 matches
requirements for the system, then no additional configuration is
required to put the unit into service. If profile 1 does not match
system requirements, it can be modified or one of the other profiles
that more closely matches the system requirements can be loaded
into current memory. When a different profile is loaded or the
existing profile is modified, it is stored in the current (nonvolatile
configuration) memory. The DSU IV ESP is then configured with
that profile every time power is turned on or the unit is reset.

CONFIGURATION METHODS

The DSU IV ESP responds to the following methods of
configuration:
•
•
•
•
•
•
61204011L1-1
AT commands
V.25 commands
Front panel commands
A VT 100 compatible terminal
SNMP/Telnet through a device running SLIP/PPP protocol
SNMP/Telnet through a LAN running ethernet protocol
(available when the optional ESP Ethernet card is installed)
DSU IV ESP User Manual 5-1