Table of Contents
Advertisement
GLASS BURNER INSTALLATION / REMOVAL
1. Angle the Glass Burner up on left side and slide the mixing tube
over the orifice.
2. Make sure to feed the Air Shutter Bar through the lower hole
in the valve tray, just above the ignitor as you place the Glass
Burner in.
Diagram 14.1
Diagram 14.2
3. Screw down the Glass Burner with two screws.
4. Hang the Front Burner Cover on the front edge.
5. To remove - reverse Steps 4-1
Regency
installation
Diagram 14.3
Diagram 14.4
E18E-11 Gas Fireplace Insert
®
|
69
Advertisement
Table of Contents
