Table of Contents
Advertisement
installation
E18E INSTALLATION SPECIFICATIONS
See Installation of E18E into Existing Units for General Installation Guidance - for vent connection configuration.
Vent Connection Type A
This install of the E18E uses
The length of 4" Flex needed is 4 -1/8" semi-expanded.
Secure flue adapter top plate to under side of existing firebox using 4 self tapping screws.
The height of the unit installed is shown below.
EP28-4 / EP28-5 INSTALLATION SPECIFICATIONS
Secure top plate to firebox w/4 screws.
Secure vent slide plate to flex pipe with 4
screws
EP28 Firebox
1. Loosen 2 x Phillips screws on both right and left legs.
Leg Setting / Outer Shell Position
2. See above diagram below for required leg setting.
3 Install with supplied Phillips screws to pre-punched holes and tighten previous screws that were loosened in Step 1.
4. Keep left side leg loose until outer firebox is in position in ZC box - to allow adjustment of gas line.
28
|
Regency
E18E-11 Gas Fireplace Insert
®
EP28 Firebox
5 5/8"
.
143mm
Leg Setting / Outer Shell Position
E18 Insert
Collar Plate Setting / Vent position
EP28 Installation Specifications
5 5/8"
A
143mm
8 7/16"
215mm
1 7/16"
37mm
A
Leg height setting
EP28 Firebox
B
8 7/16"
215mm
1 7/16"
37mm
Leg height setting
DETAIL A
SCALE 1 : 4
Flex Adaptor Length
Adaptor Plate
fastener setting
1/4"
6mm
DETAIL B
SCALE 1 : 4
Set to this
DETAIL A
SCALE 1 : 4
Right side shown
4 1/8"
105mm
4 1/8"
105mm
Set to this
hole
hole
Advertisement
Table of Contents
