Table of Contents
Advertisement
maintenance
WIRING DIAGRAMS
This heater requires a 120V A.C. supply for
operation of the circulation fan which is required
for operation of the fireplace. In case of a power
failure, the fireplace can be turned on but a
thermal safety switch will cut out the appliance
before it gets too hot. The unit will cycle on
and off as required to stay within temperature
specifications.
CAUTION: Label all wires prior
to disconnection when servicing
controls. Wiring errors can
cause improper and dangerous
operation.
86
|
Regency
E18E-11 Gas Fireplace Insert
®
Caution: Ensure that the wires do
not touch any hot surfaces and are
away from sharp edges.
When connected with 120 volts, the appliance
must be electrically grounded in accordance
with local codes or, in the absence of local
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged
(grounding) plug for your protection against shock
hazard and should be plugged directly into a prop-
erly grounded three-prong receptacle. Do not cut
or remove the grounding prong from this plug.
codes the current CSA C22.1 (in Canada) or
with the National Electrical Code ANSI/NFPA
70-1987 (in USA).
NOTE: This unit is equipped with a heat
sensor thermodisc which will
prevent the blower from operating
until the unit reaches the correct
temperature.
911-265
Diagram 21.1
Advertisement
Table of Contents
