GLASS CRYSTAL BuRNER REmOVAL / INSTALLATION (HZI540EB)
Disconnect unit from gas supply and allow unit to cool before removing
burner.
GLASS BuRNER REmOVAL
1) If already installed, removed glass crystals and pebbles.
2) Remove 4 screws that fasten the burner surround to the burner.
Screw locations
3) Remove the rear burner screen and lift out the burner surround.
4) Remove 2 screws that fasten down the burner to the firebox floor.
Screw locations
Screw locations
L540EB / HZI540EB Direct Vent Gas Insert
Burner Screen
Burner Screen
Burner Screen
Burner Surround
Burner Surround
Burner Surround
Screw locations
Screw locations
4) Lift out the burner by raising the front and pulling the burner towards you.
The mixing tube will slide out of the burner mounting bracket at the rear.
GLASS BuRNER INSTALLATION
1) Reverse removal steps to install burner.
mAINTENANCE
39