Regency Energy E18E-NG11 Owners & Installation Manual page 61

4. ZC surround installed into framed opening.
5. Separate E18E inner and outer fi reboxes - see installation into existing
unit section in the manual for details.
6. Set E18E outside fi rebox legs as shown below.
Right side shown
Outside rebox shown in position - refer to
measurements (Step 7) before securing to surround.
919-831a
7. Follow instructions in the manual for installation into a EP28-2 for
exact measurements for installation of the outside fi rebox to the sur-
round.
Secure outer rebox to the ZC faceplate
using 2 (904-897 )screws per side
Secure with
2 screws
per side
8. The top panel of the ZC surround may be removed to ease the installa-
tion of the venting - reinstall top panel after venting is installed.
Set to this
* Extra venting may be required--which is not included.
hole
9. Follow instructions in the installation into existing unit section in the
manual to complete the install of inner fi rebox.
Follow Step 10 before installing faceplate.
10. Install lower trim piece with 2 (904-897) screws to the bottom of
the ZC surround before installing faceplate.
3
installation
Regency E18E-11 Gas Fireplace Insert
®
E18E
| 61
11.29.17