Table of Contents
Advertisement
installation
GTM REMOTE INSTALLATION
1. Shut off the gas supply and disconnect all power to the unit.
2. Remove the control cover.
3. Identify short (3" long) brown wire that is attached to the white wire
coming from the DFC. Remove the 3" brown wire and discard.
4. Connect the Green wire from the GTM wire harness to the brown,
connect the white wire from the same harness to white.
5. See AC adaptor install instructions in this manual.
919-803
66
|
Regency
E18E-11 Gas Fireplace Insert
®
GTM REMOTE INSTALLATION
Discard
3" brown
wire
Brown to
Green
White
to
White
9. Plug the stepper motor into the 'motor wire as shown below.
1
6. Remove the hi/lo knob if installed by removing 2 screws as
shown below.
7. Install the stepper motor in the same location the hi/lo knob was
removed from - with 2 screws as shown below.
8. Plug wiring harness into back of receiver as shown below.
Motor Wire
E18E
06.26.17
Advertisement
Table of Contents
