installation
11. Remove Top Front Flange of Firesong firebox. (See Diagram
10.8).Remove tabs on right and left side of firebox.
12. Cut out mid section of Firesong firebox . (See Diagram 10.9).
Cut off bar at back of firebox.
Back bar
13. Remove 6 screws, one at a time, and replace with pan head
(wafer screws) - in locations shown below.
52
|
Regency
E18E-11 Gas Fireplace Insert
®
Diagram 10.8
Diagram 1.9
Diagram 10.9
Diagram 10.10
14. Cut out right side of existing Firesong firebox. (See
Diagrams 10.11,10.12 and 10.13). Left and right cutout begins
on front face - see Diagram 10.12
IMPORTANT: Cut out Firesong firebox and install support one side
at a time.
Diagram 10.11
Diagram 10.12
Diagram 10.13