Table of Contents
Advertisement
LOG TRAY INSTALLATION
LOG TRAY INSTALLATION
1. Remove the Log Burner Tray from the box. Hang the front
burner cover on the front edge of the burner tray. Place the Log
Burner Tray on the Glass Burner Tray.
2. Screw the Log Burner Tray to the Glass Burner Tray.
3. Install the Log Burner the same way as the Glass Burner (see
installation manual for instructions).
4. Fill the Log Burner with 2lbs of black glass crystals.
919-190
LOG SET INSTALLATION
LOG SET INSTALLATION
Installation of Panels must be completed before
* Log instructions shown with Black Enamel Panels
Read the instructions below carefully and refer to the images. If the logs
are broken do not use the unit until they are replaced. Broken logs can
interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can
alter the unit's performance which is not covered under warranty.
Log Kit #619-935 contains the following pieces:
A
B
C
D
E
946-675
946-669
946-708
616-515
1. Place Log A over the two posts at the back of the log burner.
2. Place Log B at the front left of the Log Tray.
B
Regency
1
installation
installing the log set.
Rear Log
Front Left Log
Front Right Log
Left Side Log
Right Side Log
2lb Fireglass
Platinum Embers
Embaglow Embers
1C Ember Lava
Log Tray Assembly
Screws x 2
A
A
E18E-11 Gas Fireplace Insert
®
E18
|
73
10/03/12
Advertisement
Table of Contents
