ZyXEL Communications 2864 Series User Manual page 93

S17 Bit-mapped register; default: 18:
Code Bits
*I0 (7,6)
*I1
*I2
D (5)
DR
*P0 (4,3,
2,1)
...
*P15
*S0 (0)
*S1
Note: The secondary channel is only available in models with network
management capability.
S18 Set DTE speed for auto answer;
Default: 0: Same value format as S20 (exception: set to 32 for 230400 bps). If
non-zero, it forces the modem to use the fixed baud rate indicated by
this value when answering. A value of zero disables this function.
S19 Modem connection mode; default: 0:
Code
&N0
&N1
&N2
&N3
&N4
&N5
Bin. Dec. Description
00 0 AT command set. (Default)
01 64 V.25bis command set.
10 128 Dumb mode (no commands accepted).
0 0 Dials and goes online normally. (Default)
1 32 Reverse dial: dials and goes online in
answer mode.
0000 0 Sets "leased-line transmission" power level.
(See also S35b3)
... ...
1111 30
0 0 Disables secondary channel. (Default)
1 1 Enables secondary channel.
Dec. Description
0 Multi-Auto; auto negotiates the highest possible
link rate. (V.34 28800 - 2400, ZyX 19200,
ZyX 16800, V.32bis 14400/12000/7200,
V.32 9600T/9600/7200T/4800, V.22bis
2400/1200, V.22 1200, BELL 212A 1200,
V.17 FAX 14400/12000/9600/7200, V.29
FAX 9600/7200, V.27ter FAX 4800/2400, cel-
lular modes)
1 V.33
2 V.33
3 V.32
4 V.32
5 V.32
14400/12000
12000
9600T/9600/7200T/4800
9600/7200T/4800
4800
8–7