ZyXEL Communications 2864 Series User Manual page 163

+FCC=vr,br,wd,ln,
df,ec,bf,st
+FCLASS=n
+FCO
+FCQ=<rq>,<tq>
+FCR=n
+FCT=n
+FDR
+FDT
+FEA=n
+FIE=n
+FIP
DCE capability parameter: refer to the +FDCC
Class 2 command on page 15-4 for parameter
settings.
Service class selection: refer to the +FCLASS
Class 1 command on page 15-2.
DCE response: fax connection is made.
Copy quality check capability parameter:
rq=0 DCE Receive Copy Quality Checking is disabled.
rq=1 DCE Receive Copy Quality Checking is enabled.
rq=2 DCE Receive Copy Quality Correction is enabled.
tq=0 DCE Transmit Copy Quality Checking is disabled.
tq=1 DCE Transmit Copy Quality Checking is enabled.
tq=2 DCE Transmit Copy Quality Correction is enabled.
"Capability to receive" parameter:
n=0 The DCE will not receive message data or poll
a remote device.
n=1 The DCE receives message data or polls a
remote device.
0-255 DTE phase C time-out parameter. n=0-255, 1s
units.
Receive phase C data command: initiates doc-
ument reception.
Transmit phase C data command: releases the
DCE to proceed with the negotiation.
Phase C received EOL alignment parameter:
n=0 Determines that T.4 EOL patterns are bit
aligned (as received).
n=1 Determines that the last received bits of T.4 EOL
patterns are byte aligned by the DCE, with nec-
essary zero fill bits inserted.
Procedure interrupt parameter:
n=0 Procedure interrupt requests from the remote sta-
tion are ignored, and are not reported to the DTE.
n=1 Procedure interrupt requests from the remote
station are accepted, negotiated and reported
using the +FVO response.
Initializes facsimile parameters to factory
default.
15–9