Repeat Last Dial; Auto Answer - ZyXEL Communications 2864 Series User Manual

When you want to switch from modem to voice communication, simply lift up the
handsets of both sides and press the ENTER key while the blinking cursor is on the
H or Hang Up. The LCD display will show DISCONNECTING ? to ask for a confir-
mation. Press ENTER again and the modem will change from data to voice commu-
nication. When both sides wish to return to data communication, one side should
press O while the other side presses A (as explained previously). This operation will
reinitiate the modem handshaking and enable data communication.
For the non-LCD model, use the VOICE/DATA toggle switch for data/voice switching
and use the ORG/ANS switch to select originate mode or answer mode on-line. For
the Omni model, the AT*Mn command or S14b0 will decide originate or answer
mode on a manual connection. Whenever your modem establishes a connection
with another modem, one of the modems must be in answer mode and the other
modem in originate mode or a connection is not possible.
Equivalent AT Commands
Escape sequence code; causes a modem to return to command
+++
state. Enter the escape sequence while in data state and wait for the
modem to respond.
Go on-hook; disconnect the modem.
ATH
Go on-line in Originate mode.
ATD
Go on-line in Answer mode.
ATA

Repeat Last Dial

Access R (Repeat last dial) by pressing the left or right arrow key and the ENTER key.
Before a connection is made, any key pressed from the front panel or terminal key-
board will abort the redial operation.
Equivalent AT Commands
Repeat last dial.
ATDL
Repeat last command once.
A/
Repeat last command once, retry the last call up to 9 times. (coun-
A>
try specific)

Auto Answer

Move to the STATUS REGISTER menu, and change the S0 value to the desired
number of rings until the modem automatically answers. Setting this value to zero
disables auto answer.
Equivalent AT Commands
Disable auto answer.
ATS0=0
Automatically answer on the nth ring.
ATS0=n
5–6