ZyXEL Communications 2864 Series User Manual page 122

Leased-line auto-handshake on answer mode.
*M1
*P0-15 Sets leased-line transmission power level, range from 0 dBm to
-15 dBm (Default = -9 dBm); range from -12 dBm to -27 dBm if
S35b3 is set. The maximum transmission power for Omni 288P
and 288S is -9dBm and -3dBm, respectively.
No action to poor signal quality.
*Q0
Retrain action taken if signal quality is poor.
*Q1
+ Adaptive rate; auto fall-back or fall-forward. (Default)
*Q2
Disconnect for poor signal quality.
*Q3
Read remote profile b to local profile a:
*Rab
a= 0-3,
b= 0-3,
Note: The command *Rab only works when the modem is on-line, inde-
pendent of the type of connection involved.
+ Secondary channel disabled. (Default)
*S0
Secondary channel enabled.
*S1
Displays last caller ID message.
*T
Views password table.
*V
Note: This command requires the supervisor password before execution.
Writes the local configuration profile a to remote user profile b and
*Wab
resets the remote modem from that profile:
a= 0-3,
4,
5,
b= 0-3,
Note: The command *Wab only works when the modem is on-line inde-
pendent of the type of connection involved.
local user profile number.
remote user profile number.
4, remote active configuration.
5, remote factory default.
local user profile number.
local active configuration.
local factory default settings.
remote user profile number.
9–12