Extended At& Command Set - ZyXEL Communications 2864 Series User Manual

Escape sequence code, entered in data state, wait for modem to
+++
return to command state.
Basic command summary help.
$
Extended AT& command summary help.
&$
Extended AT* command summary help.
*$
Extended AT& Command Set
DTE/DCE rate follows link rate. (If the communication software
&B0
package has auto baud rate detection, please turn it ON.) (See also
S44b6)
+ Fixes the DTE/DCE to the DTE setting, range from 300 bps to
&B1
460.8 Kbps. (Default) (See also S18, S20, S44b6)
Assumes that the carrier is always present; forces CD to always
&C0
remain ON.
+ CD tracks presence of carrier. (Default) (See also S38b3 and
&C1
S42b7)
Ignores DTR signal, assumes DTR to always remain ON.
&D0
108.1, DTR OFF-ON transition causes dial of the default number.
&D1
(See also *Dn)
+ 108.2, Data Terminal Ready, DTR OFF causes the modem to hang
&D2
up and return to command state. (Default)
Same as &D2, but DTR OFF also causes the loading of and reset
&D3
with data from profile 0.
Loads factory settings to RAM as active configuration.
&F
+ No guard tone (within the USA, Canada). (Default)
&G0
Reserved.
&G1
1800 Hz guard tone.
&G2
Disables flow control.
&H0
Reserved.
&H1
Reserved.
&H2
+ Hardware CTS/RTS flow control. (Default)
&H3
Software XON/XOFF flow control.
&H4
Reserved.
&H5
+ Single phone line RJ11 phone jack. (Default)
&J0
Multiple-phone/modem line RJ12/RJ13 phone jack.
&J1
9–6