Command Echo - ZyXEL Communications 2864 Series User Manual

RTS OPTIONS
+ IGNORED
CTS TRACKS
RTS
Note: Effective only in synchronous mode. This setting is ignored in asyn-
chronous mode. RTS is always used as a hardware flow control sig-
nal in this case.
DSR OPTIONS
+ ALWAYS ON
DATA SET
READY

COMMAND ECHO

+ ENABLED
DISABLED
RESULT CODE
+ ENABLED
DISABLED
DTE ASYNC SPEED
230400
115200
76800
57600
38400
19200
16800
14400
The modem assumes that RTS is always ON
AT&R1
and ignores the serial port signals. (Default)
Delay before CTS responds to RTS's change.
AT&R0
The delay is set in S26.
The modem forces DSR to always remain ON.
AT&S0
(Default)
According to ITU-T. DSR ON during handshake.
AT&S1
If S41.5=1, DSR follows CD, and pulses off for
0.5 sec for CD on-off transition. If S44.4=1,
DSR follows DTR.
The modem echoes commands. (Default)
ATE1
The modem does not echo commands.
ATE0
The modem returns result codes. (Default)
ATQ0
The modem does not return result codes.
ATQ1
If S40.1=1, the modem does not return result
ATQ2
codes in answer mode.
Selects DTE port asynchronous serial speed. AT
command auto speed detection will override
this selection.
307200
153600
102400
61400
51200
6–5