ZyXEL Communications 2864 Series User Manual page 76

PANEL LOCK
+ UNLOCK
LOCK
Note: When the panel key is locked, it can only be used to view menu
items but not to make changes. You can use the PANEL LOCK menu
to lock the key, but you cannot unlock the key from this menu. Press
the left and right buttons simultaneously , or use AT*L1 to unlock
the key. However, you can use this menu to view panel lock status.
SYNC CLOCK
+ INTERNAL
EXTERNAL
SLAVE
AUTO HANDSHAKE
+ ORIGINATE
ANSWER
Note: If you need two modems to automatically connect on a leased line
when the power is turned ON, one modem must be set to originate
mode, and the other set to answer mode. These settings should be
saved in the power-on default profile.
LINE TYPE
+ DIAL-UP
2W LEASED
4W LEASED
Note: For information about wiring a leased line, please refer to
appendix B. Models without a leased-line jack can only be connect-
ed to a 2-wire leased line through their dial-up jack.
Panel key operation is normal. (Default)
AT*L0
Panel key is ocked.
AT*L1
The modem provides the transmission clock.
AT&X0
(Default)
The DTE provides the transmission clock.
AT&X1
The modem's receiver clock is used as the
AT&X2
transmission clock.
When operating on a leased line, the modem
AT*M0
will handshake in originate mode. (Default)
When operating on a leased line, the modem
AT*M1
will handshake in answer mode.
The modem is connected to a dial-up telephone
AT&L0
line. (Default)
The modem is connected to a 2-wire leased
AT&L1
line; plug the phone jack into the LEASED LINE
receptacle at the rear of the modem.
The modem is connected to a 4-wire leased
AT&L2
line. Plug into the LEASED LINE receptacle.
6–10