ZyXEL Communications 2864 Series User Manual page 165

+FNS=" "
string
+FPI=" "
string
+FPP=n
+FPR=n
+FPS=n
+FRQ=pgl, cbl
+FRY=n
+FSP=n
Non-standard byte string parameter.
"string": string of hexadecimally coded octets.
Local fax station ID string, for polling Rx.
Packet protocol control parameter:
n=0 Disables the DCE-DTE packet protocol.
n=1 Enables the DCE-DTE packet protocol. All multi-
character messages from the DCE are sent to the
DTE using a simple packet protocol data link.
Serial port rate control parameter:
n=0 Automatic DTE rate detection by the DCE.
n>0 Serial rate is fixed at the value multiplied by
2400bps. For example, when n=8, the DTE
rate is equal to 19200bps (8x2400).
Page transfer status: refer to the +FPTS Class 2
command on page 15-6 for parameter
descriptions.
Receiving quality thresholds parameters:
pgl= Specifies the percentage of good lines (e.g. with
negotiated number of pixels) required for a page
0-64
considered acceptable. The percentage of good
(HEX
lines would be computed by the equation:
value)
100 x (<lc> - <bl>) / <lc>
lc: total line count as reported in the +FPS:
response.
bl: bad line count as reported in the +FPS:
response.
If the resulting value is less than the value in
<pgl>, the page is unacceptable.
cbl= Specifies the maximum tolerable number of
0-FF consecutive bad lines. If this value is exceeded
(HEX for a given page, the DCE shall consider the
value) page unacceptable.
0-255 ECM retry value: n=0-255, units of 4 retries.
Enable polling command:
n=0 Disables polling.
n=1 Enables polling.
15–11