ZyXEL Communications 2864 Series User Manual page 119

+ Pulse dial make/break ratio= 39%:61%. (Default)
&P0
Pulse dial make/break ratio= 33%:67%.
&P1
CTS tracks RTS, response delay is set in S26.
&R0
+ The modem assumes that RTS is always ON, ignores the changes.
&R1
(Default)
Note: &Rn controls the synchronous mode operation only. In asynchro-
nous mode, CTS/RTS are used for flow control.
+ The modem forces DSR to always remain ON. (Default)
&S0
DSR according to ITU-T. If S44.4=1, DSR follows DTR. If
&S1
S41.5=1, DSR is always on, but follows CD off for 0.5 second.
Terminates test in progress.
&T0
Initiates Analog LoopBack (ALB) test.
&T1
Reserved.
&T2
Initiates Local Digital Loopback (LDL) test.
&T3
Grants Remote Digital Loopback request from the remote modem.
&T4
+ Denies Remote Digital Loopback request from the remote modem.
&T5
(Default)
Initiates Remote Digital Loopback (RDL) test.
&T6
Initiates Remote Digital Loopback with self test (RDL+ST).
&T7
Initiates Analog LoopBack with self test (ALB+ST).
&T8
Views current active settings.
&V0
Views user profile 0 settings.
&V1
Views user profile 1 settings.
&V2
Views user profile 2 settings.
&V3
Views user profile 3 settings.
&V4
Views factory default settings.
&V5
Saves current settings to user profile 0. (See also S35b6)
&W0
Saves current settings to user profile 1.
&W1
Saves current settings to user profile 2.
&W2
Saves current settings to user profile 3.
&W3
+ The modem provides synchronous transmit clock signal. (Internal
&X0
clock to pin 15 of EIA-232D.) (Default)
9–9