ZyXEL Communications 2864 Series User Manual page 162

Response
+FNSC:"
HEX string
+FNSF:"
HEX string
+FNSS:"
HEX string
+FPOLL
+FPTS:n
+FTSI:"string"
+FVOICE
Class 2 Flow Control
Flow control is necessary to match the DTE-DCE data rate to the line signaling
rate while transmitting or receiving Group 3 (T.4) data. In Class 2 fax mode, both
hardware (RTS/CTS) and software (XON/XOFF) flow control are enabled.
CLASS 2.0 "AT+F" COMMAND SET.
Command Syntax
+<command>=<value>
+<command>=?
+<command>?
Commands
Command
+FAA=n
+FBO=n
+FBS?
Value Function and Description
n=70 Receives the error on phase B hang up code.
n=90 Receives the error on phase C hang up code.
n=100 Receives the error on phase D hang up code.
" Reports the non-standard facilities command
frame.
" Reports the non-standard facilities frame re-
sponse.
" Reports the non-standard setup frame re-
sponse.
Remote polling indication.
Receive page transfer status response; refer to
+FPTS=n command.
Report remote ID response TSI.
Transition to Voice response.
Description
Executes a command or sets a parameter.
Reads permissible settings.
Reads the current setting.
Value Description
Auto-answer mode parameter:
n=0 The DCE answers as set by +FCLASS.
n=1 The DCE answers and auto-determines the call
type.
Phase C data bit order:
n=0 Selects direct bit order.
n=1 Selects reversed bit order in receiving mode for
phase C data.
Buffer size parameter; read only.
15–8