YASKAWA Varispeed V7 Instruction Manual page 92

6. Operating with DeviceNet Communications
Data Name
Byte 0, Running
bit 0
Byte 0, ZSP
bit 1
Byte 0, Rev Run-
bit 2 ning
Byte 0, Reset
bit 3
Byte 0, At Refer-
bit 4 ence
Byte 0, Ready
bit 5
Indicates the Inverter's operating status.
0: Stopped.
1: Operating forward, operating in
reverse, or applying DC injection
braking.
Indicates the Inverter's operating status.
0: Operating forward or in reverse.
1: Stopped or applying DC injection
braking.
Indicates the Inverter's operating status.
0: Operating forward, stopped (Reverse
RUN command OFF), or applying DC
injection braking (Reverse RUN com-
mand OFF).
1: Operating in reverse, stopped
(Reverse RUN command ON), or
applying DC injection braking
(Reverse RUN command ON).
Indicates the input status of the
Inverter's RESET signal.
0: ---
1: RESET signal being input.
Indicates that the Inverter's frequency
match was detected.
0: Stopped, accelerating, or decelerat-
ing.
1: Frequency matches.
Indicates the Inverter's preparation sta-
tus.
0: Fault detected or initializing.
1: Preparations for operation completed.
Contents
91