Table of Contents
Advertisement
6. Operating with DeviceNet Communications
Data
Name
Byte 0,
Faulted
bit 7
Byte 1,
OPE
bit 0
Byte 1,
UV
bit 1
Byte 1,
Fnc. State
bit 2
1
Byte 1,
Fnc. State
bit 3
2
Byte 1,
Local/Re-
bit 4
mote
Byte 1,
Terminal
bit 5
MA*
Byte 1,
Terminal
bit 6
P1
Indicates that the Inverter detected a
fault.
0: Normal
1: Fault detected.
Indicates that the Inverter detected a
MEMOBUS constant setting error
(OPE).
0: Normal
1: OPE (OP1 to OP5) detected.
Indicates that the Inverter detected an
undervoltage error.
0: Normal
1: UV detected.
See the table MEMOBUS Function Sta-
tus on page 87 for details.
Indicates which RUN command input
has been selected in the Inverter.
0: A RUN command input other than
DeviceNet is enabled.
1: The RUN command input from
DeviceNet is enabled.
Indicates the output status of Inverter
multi-function output terminal MA.
0: Terminal MA OFF
1: Terminal MA ON
Indicates the output status of Inverter
multi-function output terminal P1.
0: Terminal P1 OFF
1: Terminal P1 ON
Contents
85
Advertisement
Chapters
Table of Contents
