YASKAWA Varispeed V7 Instruction Manual page 163

Setting
0
1
Communications/Multi-function Input Terminal Selection
(Setting: 18)
Operation can be changed from DeviceNet communications commands,
or from multi-function input terminal or Digital Operator commands.
RUN commands from communications and the frequency reference are
effective when the multi-function input terminal for this setting is
closed.
RUN commands in LOCAL/REMOTE mode and the frequency refer-
ence are effective when the terminal is open.
Using the Multi-function Analog Inputs (n077, n078)
The input analog signal (0 to 10 V or 4 to 20 mA) for the CN2 terminal
of the JVOP-140 Digital Operator can be used as the main speed fre-
quency reference. Refer to the block diagram on page 185 for details on
the input signal.
NOTE
Multi-function Input Selection (n077)
No.
n077 Multi-function Input Selection
162
Output frequency is not recorded during
HOLD.
When HOLD status is continued for 5 seconds
or longer, the output frequency during HOLD
is recorded and the Inverter restarts at the re-
corded frequency.
When using the signal for the CN2 terminal of the JVOP-140
Digital Operator as a multi-function analog input, never use it
for the target value or the feedback value of PID control. (PID
control is disabled when n128 is set to 0.)
Name
Description
Unit Setting
Range
- 0 to 4
Factory
Setting
0