Table of Contents
Advertisement
READ Function
Reads out the constants in batch from the Inverter and stores them in
EEPROM inside the Digital Operator. When the read-out is executed,
the previously stored constants data in the EEPROM are cleared and
replaced with the newly entered constants.
Example: Storing Constants from Inverter in EEPROM in Operator.
•
Enable the setting of
constants n001 to
n179.
•
Set Contant Read
Prohibited Selection
(n177) to read-
enabled.
•
Execute read-out
(READ) using the
Constant Copy
Function Selection
(n176).
•
Set Constant Read
Prohibited Selection
(n177) to read-dis-
*2
abled.
Note: 1. When reading is enabled (n177=1), this setting is not necessary.
188
Explanation
•
Press DSPL to light
[PRGM].
•
Press ENTER to display
the set value.
•
Change the set value to 4
by pressing the
key.
•
Press ENTER.
•
Change the constant No.
to n177 by pressing the
*1
or
•
Press ENTER to display
the set value.
•
Change the set value to 1
by pressing the
key.
•
Press ENTER.
•
Change the constant No.
by pressing the
key.
•
Press ENTER to display
the set value.
•
Change the set value to
rEd by pressing the
key.
•
Press ENTER.
•
Press DSPL or ENTER.
•
Change the constant No.
to N177 by pressing the
or
•
Press ENTER to display
the set value.
•
Change the set value to 0
by pressing the
key.
•
Press ENTER.
or
key.
or
or
or
key.
or
Operator Display
(May be a different constant No.)
(Lit)
(May be a different set value.)
(Blinks)
(Lit for one second.)
(The constant is displayed.)
(Lit)
(Blinks)
(Lit for one second.)
(The constant is displayed.)
(Lit)
(Lit)
(Flashes while executing
the read)
(End is displayed after the
read has been completed.)
(The constant is
displayed.)
(Lit)
(Flashes)
(Lit for one second.)
(The constant No. is
displayed.)
Advertisement
Chapters
Table of Contents
