Jeep H6 Manual page 112

23_H6_OM_EN_IN_t.book Page 112
112 STARTING AND OPERATING
Automatic Transmission
The gear selector must be in the NEUTRAL or PARK
position before you can start the engine. Apply the
brakes before shifting into any driving gear.
CAUTION!
Damage to the transmission may occur if the
following precautions are not observed:
Do not shift between PARK, REVERSE,

NEUTRAL, or DRIVE when the engine is above
idle speed.
Shift into or out of PARK or REVERSE only after

the vehicle has come to a complete stop.
Before shifting into any gear, make sure your

foot is firmly on the brake pedal.
Keyless Ignition Functions — Using The ENGINE
START/STOP Button
1. The transmission must be in PARK or
NEUTRAL.
2. Press and hold the brake pedal while pushing
the ENGINE START/STOP button once.
3. The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the
starter will disengage automatically after
10 seconds.
4. If you wish to stop the cranking of the engine
prior to the engine starting, push the button
again.
Keyless Ignition Functions — With Driver's Foot Off
The Brake Pedal/Clutch Pedal (In PARK Or
NEUTRAL Position)
The Keyless Ignition feature operates similar to an
ignition switch. It has three positions, OFF, ON/
RUN, and START. To change the ignition position
without starting the vehicle and use the
accessories, follow these steps (starting with the
ignition switch in the OFF position):
1. Push the ENGINE START/STOP button once to
change the ignition switch to the ON/RUN
position.
2. Push the ENGINE START/STOP button a
second time to change the ignition switch to
the OFF position.
Manual Transmission
The gear selector must be in the NEUTRAL position
before you can start the engine. Apply the brakes
before shifting into any driving gear.
Keyless Ignition Functions — Using The ENGINE
START/STOP Button
1. The transmission must be in NEUTRAL.
2. Press and hold the clutch pedal while pushing
the ENGINE START/STOP button once.
3. The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the
starter will disengage automatically after
10 seconds.
4. If you wish to stop the cranking of the engine
prior to the engine starting, push the button
again.