Battery Saver Feature; Interior Lights; Interior Courtesy Lights - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 52
52 GETTING TO KNOW YOUR VEHICLE
B S F
ATTERY AVER EATURE
To protect the battery, the interior lights will turn off
automatically 15 minutes after the ignition switch
is placed in the OFF position. This will occur if the
interior lights were switched on manually or are on
because a door is open.

INTERIOR LIGHTS

I C L
NTERIOR OURTESY IGHTS
Courtesy and dome lights are turned on when the
front doors are opened, or when the dimmer
control is rotated to its farthest upward position.
The courtesy lights feature allows you to activate
the low beam, parking lights, and side marker
lights for 25 seconds when the vehicle is unlocked
(through the key fob or the Passive Entry door
handles [if equipped]).
NOTE:
The courtesy lights feature can be activated or

deactivated through the Uconnect Settings
Ú page 157.
When a door is open with the feature active, the

activation of the lights is extended for five
seconds.
The feature is disabled when the vehicle is

locked or when the ignition is placed in the ON/
RUN position.
The front map/reading lights are turned on by the
switches in the center of the overhead console.
Overhead Light Switches
To protect the battery, the interior lights will turn off
automatically 15 minutes after the ignition is
placed in the OFF position. This will occur if the
interior lights were turned on manually or are on
because a door is open. This includes the glove
compartment light and the cargo area light. To
restore interior light operation, either place the
ignition in the ON/RUN position, or push the light
switch on and then back off.
Instrument Panel Dimmer Control
The instrument panel dimmer control is part of the
headlight switch and is located on the driver's side
of the instrument panel.
Rotating the instrument panel dimmer up or down
will adjust the brightness of the instrument panel
lights ONLY when the parking lights or headlights
are turned on, AND ONLY if the built-in cluster light
sensor determines that the ambient light levels are
low enough that the backlighting should be
enabled.