Jeep H6 Manual page 237

23_H6_OM_EN_IN_t.book Page 237
4. Place the jack underneath the lift area that is
closest to the flat tire. Turn the jack screw
clockwise to firmly engage the jack saddle with
the lift area of the sill flange, centering the jack
saddle inside the cutout in the sill cladding.
Front Lifting Point
Front Jacking Location
5. Raise the vehicle just enough to remove the
Raising the vehicle higher than necessary can
make the vehicle less stable. It could slip off the
jack and hurt someone near it. Raise the vehicle
only enough to remove the tire.
6. Remove the wheel bolts and tire.
Rear Lifting Point
7. Thread the alignment pin into the wheel hub to
IN CASE OF EMERGENCY
Rear Jacking Location
flat tire.
WARNING!
assist in mounting the spare tire.
237