Jeep H6 Manual page 268

23_H6_OM_EN_IN_t.book Page 268
268 SERVICING AND MAINTENANCE
WARNING!
Before replacing a fuse, make sure that the

ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an

authorized dealer.
If a general protection fuse for safety systems

(air bag system, braking system), power unit
systems (engine system, transmission
system) or steering system blows, contact an
authorized dealer.
The fuses protect electrical systems against
excessive current.
When a device does not work, you must check the
fuse element inside the blade fuse for a break/
melt.
Also, please be aware that using power outlets for
extended periods of time with the engine off may
result in vehicle battery discharge.
CAUTION!
If it is necessary to wash the engine
compartment, take care not to directly hit the
fuse box, and the windshield wiper motors with
water.
Blade Fuses
1 — Fuse Element
2 — Blade Fuse with a good/functional fuse
element
3 — Blade fuse with a bad/not functional fuse
element (blown fuse)
Power Distribution Center/Fuses
The Power Distribution Center (PDC) is located on
the driver side of the engine compartment, behind
the headlamp. This center contains cartridge
fuses, micro fuses, relays, and circuit breakers.
The following chart corresponds to the fuses
inside.
CAUTION!
When installing the power distribution center
cover, it is important to ensure the cover is
properly positioned and fully latched. Failure to
do so may allow water to get into the power
distribution center and possibly result in an
electrical system failure.