Jeep H6 Manual page 222

23_H6_OM_EN_IN_t.book Page 222
222 SAFETY
3. Attach the connectors of the child restraint to
the lower anchorages in the selected seating
position.
4. If the child restraint has a tether strap, connect
it to the top tether anchorage. See
Ú page 222 for directions to attach a tether
anchor.
5. Tighten all of the straps as you push the child
restraint rearward and downward into the
seat. Remove slack in the straps according to
the child restraint manufacturer's instructions.
6. Test that the child restraint is installed tightly
by pulling back and forth on the child seat at
the belt path. It should not move more than
25 mm in any direction.
WARNING!
Improper installation of a child restraint to the

ISOFIX anchorages can lead to failure of the
restraint. The child could be badly injured or
killed. Follow the child restraint manufac-
turer's directions exactly when installing an
infant or child restraint.
Child restraint anchorages are designed to

withstand only those loads imposed by
correctly-fitted child restraints. Under no
circumstances are they to be used for adult
seat belts, harnesses, or for attaching other
items or equipment to the vehicle.
Install the child restraint system when the

vehicle is stationary. The ISOFIX child restraint
system is correctly fixed to the brackets when
you hear the click.
Installing Child Restraints Using The Top
Tether Anchorage:
1. Look behind the seating position where you plan
to install the child restraint to find the tether
anchorage. If the seat can be moved, you may
need to move the seat forward to provide better
access to the tether anchorage. If there is no top
tether anchorage for that seating position, move
the child restraint to another position in the
vehicle if one is available.
2. Route the tether strap to provide the most
direct path for the strap between the anchor
and the child seat. If your vehicle is equipped
with adjustable rear head restraints, raise the
head restraint, and where possible, route the
tether strap under the head restraint and
between the two posts. If not possible, lower
the head restraint and pass the tether strap
around the outboard side of the head restraint.
3. Attach the tether strap hook of the child
restraint to the top tether anchorage as shown
in the diagram.