Ignition Switch; Keyless Enter 'N Go™ Ignition - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 23

IGNITION SWITCH

K E ' G ™ I
EYLESS NTER N O GNITION
This feature allows the driver to operate the
ignition with the push of a button as long as the key
fob is in the passenger compartment.
The START/STOP ignition button has three
operating modes. The three modes are OFF, ON/
RUN, and START.
START/STOP Ignition Button
1 — OFF
2 — ON/RUN
The push button ignition can be placed in the
following modes:
OFF
The engine is stopped.

Some electrical devices (e.g. power locks,

alarm, etc.) are still available.
ON/RUN
Driving mode.

All the electrical devices are available (e.g.

climate controls, etc.).
START
The engine will start.

NOTE:
If the ignition state/mode does not change with the
push of a button, the key fob may have a low or
depleted battery. In this situation, a backup
method can be used to operate the ignition switch.
Put the nose side (side opposite of the emergency
key) of the key fob against the START/STOP
ignition button and push to operate the ignition.
GETTING TO KNOW YOUR VEHICLE
Starting The Ignition With Depleted Key Fob Battery
WARNING!
Before exiting a vehicle, always come to a

complete stop, then shift the automatic trans-
mission into PARK, apply the parking brake,
place the engine in the OFF position, remove
the key fob from the vehicle and lock your
vehicle. If equipped with Keyless
Enter 'n Go™, always make sure the keyless
ignition is in OFF position, remove the key fob
from the vehicle and lock the vehicle.
(Continued)
23