Parkview Rear Back Up Camera; If Equipped - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 142
142 STARTING AND OPERATING
false indication that an obstacle is behind the
fascia/bumper.
Use the ParkSense switch to turn the ParkSense

system off if objects such as bicycle carriers,
etc. are attached to the rear fascia/bumper.
Failure to do so can result in the system misin-
terpreting a close object as a sensor problem,
causing the "PARKSENSE UNAVAILABLE
SENSORS BLOCKED" message to be displayed
in the instrument cluster display.
NOTE:
If any objects are attached to the fascia/bumper
within a 6.5 ft (2 m) field of view, they will interfere
and cause false alerts and possibly blockage.
WARNING!
Drivers must be careful when backing up even
when using ParkSense. Always check carefully
behind your vehicle, look behind you, and be sure
to check for pedestrians, animals, other vehicles,
obstructions, and blind spots before backing up.
You are responsible for safety and must continue
to pay attention to your surroundings. Failure to do
so can result in serious injury or death.
CAUTION!
ParkSense is only a parking aid and it is

unable to recognize every obstacle, including
small obstacles. Parking curbs might be
temporarily detected or not detected at all.
Obstacles located above or below the sensors
will not be detected when they are in close
proximity.
The vehicle must be driven slowly when using

ParkSense in order to be able to stop in time
when an obstacle is detected. It is recom-
mended that the driver looks over his/her
shoulder when using ParkSense.
PARKVIEW REAR BACK UP CAMERA —

IF EQUIPPED

The ParkView Rear Back Up Camera allows you to
see an on-screen image of the rear surroundings of
your vehicle whenever the gear selector is put into
REVERSE. The image will be displayed on the
Navigation/Multimedia radio display screen along
with a caution note to "Check Entire Surroundings"
across the top of the screen. After five seconds this
note will disappear. The ParkView camera is
located on the rear of the vehicle above the rear
license plate.
If the liftgate is opened while the ParkView Rear
Back Up Camera is being displayed, a caution note
"Camera Not in Position" will be displayed across
the top of the screen for five seconds.
Manual Activation Of The Rear View Camera
1. Press the Vehicle button located on the
bottom of the Uconnect display and then
select the Controls menu.
2. Press the Back Up Camera button to turn the
Rear View Camera system on.
NOTE:
The ParkView Rear Back Up Camera has program-
mable modes of operation that may be selected
through the Uconnect system Ú page 157.
When the vehicle is shifted out of REVERSE with
camera delay turned off, the rear camera mode is
exited and the previous screen appears. When the
vehicle is shifted out of REVERSE with camera
delay turned on, the camera image will continue to