Jeep H6 Manual page 236

23_H6_OM_EN_IN_t.book Page 236
236 IN CASE OF EMERGENCY
WARNING!
Block the wheel diagonally opposite the wheel

to be raised.
Set the transmission in PARK and activate the

Electric Park Brake.
Never start or run the engine with the vehicle

is on a jack.
Do not let anyone sit in the vehicle when it is

on a jack.
Do not get under the vehicle when it is on a

jack. If you need to get under a raised vehicle,
take it to a service center where it can be
raised on a lift.
Only use the jack in the positions indicated

and for lifting this vehicle during a tire change.
If working on or near a roadway, be extremely

careful of motor traffic.
To assure that spare tires, flat or inflated, are

securely stowed, spares must be stowed with
the valve stem facing the ground.
Jack Warning Label
1. Remove the jack and necessary tools.
2. If equipped with aluminum wheels where the
center cap covers the wheel bolts, use the lug
nut wheel wrench to pry the center cap off
carefully before raising the vehicle.
3. Before raising the vehicle, use the lug nut
wheel wrench to loosen, but not remove, the
wheel bolts on the wheel with the flat tire. Turn
the wheel bolts counterclockwise one turn
while the wheel is still on the ground.
NOTE:
Placement for the front and rear jack locations are
critical. See following images for proper jacking
locations.
Jacking Locations
CAUTION!
Do not attempt to raise the vehicle by jacking on
locations other than those indicated in the
Jacking Instructions for this vehicle.