Front Ventilated Seats - If Equipped; Head Restraints - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 42
42 GETTING TO KNOW YOUR VEHICLE
Power Lumbar — If Equipped
Vehicles equipped with power driver or passenger
seats may be equipped with power lumbar. The
power lumbar switch is located on the outboard
side of the power seat. Push the switch forward to
increase the lumbar support. Push the switch
rearward to decrease the lumbar support. Pushing
upward or downward on the switch will raise and
lower the position of the support.
Power Lumbar Switch
F V S —
RONT ENTILATED EATS
I E
F QUIPPED
Located in the seat cushion and
seatback are fans that draw the air from
the passenger compartment and move
air through fine perforations in the seat
cover to help keep the driver and front passenger
cooler in higher ambient temperatures. The fans
operate at two speeds, HI and LO.
The front ventilated seats control buttons are
located within the Uconnect system. You can gain
access to the control buttons through the climate
screen or the controls screen.
Press the ventilated seat button once to choose

HI.
Press the ventilated seat button a second time

to choose LO.
Press the ventilated seat button a third time to

turn the ventilated seat off.
If your vehicle is equipped with a medium fan
setting:
Press the ventilated seat button once to choose

HI.
Press the ventilated seat button a second time

to choose MED.
Press the ventilated seat button a third time to

choose LO.
Press the ventilated seat button a fourth time to

turn the ventilated seat off.
NOTE:
The engine must be running for the ventilated
seats to operate.
H R
EAD ESTRAINTS
Head restraints are designed to reduce the risk of
injury by restricting head movement in the event of
a rear impact. Head restraints should be adjusted
so that the top of the head restraint is located
above the top of your ear.