Front Panel Chilled Water Setpoint; Front Panel Current Limit Setpoint; Print Report - Trane CVRC-M-1D Manual

44
Operator Settings

Front Panel Chilled Water Setpoint

Front Panel Chilled Wtr Setpt:
Press <+> <- > to Change Setting
Range of Values is 0 to 65 F (-17.8 to 18.3C) in increments of 1 or 0.1 F
or C depending on the Service Setup Screen XXX or XXX.X. Factory
default is 44.0 F (6.7 C).
As shown above, the second line of a setting display normally says:
"Press - to Change Setting"
The following is displayed as the second line of the display if an attempt
is made to increment the setpoint above the end of the setpoint range:
"Top of Range, Press - to Change"
The following is displayed as the second line of the display if an attempt
is made to decrement the display below the end of the setpoint range:
"Bottom of Range, Press
The following is displayed as the second line of the display if a key other
then <+>, <->, <Enter>, or <Cancel> is pressed after <+> or <- > is
pressed:
"Press - Enter Cancel to Advance"
The exception to the above message is when the <Stop> key is
depressed. Stop is always active. Other messages are displayed on the
second line of the display for special cases as noted below in association
with the affected setpoint display.
When the Front Panel Chilled Water Setpoint is within 1.7 F of the
Leaving Water Temperature Cutout Setpoint or within 6 F of the Low
Refrigerant Temperature Cutout Setpoint, the second line of this display
will read:
"Limited by Cutout Setpt,

Front Panel Current Limit Setpoint

Front Panel Current Limit Stpt:
Press <+> <- > to Change Setting
Range of Values is 40 to 100% in increments of 1% Factory Default is
100%

Print Report

This screen is shown only when the Printer Option is installed.
Press (Enter) to Print Report
Press (Next) (Previous) To Continue
When Enter is pushed a second message appears as shown below and
then returns to above screen.
The Print Command is Being
XXX.X F/C
to Change"
to Change"
XXX %
Sent to the Printer
CVRC-M-1D