Trane CVRC-M-1D Manual page 8

b. Control Panel
[ ] All terminals tightened.
[ ] Wires free from abrasion, kinks and sharp corners.
[ ] Low voltage wires are isolated from high voltage wires.
[ ] Panel is free of debris, dust, etc.
[ ] "Power up" the control panel.
[ ] Set up all menus and then record the settings found in the Operator Settings, Service Settings
Field startup Group and Machine Configuration Menus in the FastPak.
[ ] If Evaporator and/or condenser water pumps are controlled by the FastPak, use the Service Test
menu of the FastPak to manually start and test the control of the pumps.
[ ] Check the setting of the oil pressure regulating valve.
1. Use the Service Test Menu of the fastPak to manually start the oil pump.
2. Observe the Differential Oil Pressure.
3. If necessary, adjust the oil pressure regulating valve.
4. This procedure also checks to ensure correct sensing of oil pressure.
5. Return Oil Pump control to "auto".
[ ] Check vane operator and vanes
1. Use the Service Test Menu of the fastPak to manually over ride the vane control.
2. Enter targets from 0% to 100% and observe vane operation. At minimum and
maximum travel, the operator should not exert any force on the vane assembly.
Adjust as required.
3. Vane movement is smooth to open/close.
4. Vane movement is reported back to FastPak.
5. Return Vane control to "auto".
B. Preparation for startup
1. Electrical
[ ] Disconnect all temporary power cords, replace all fuses, connect motor leads, make final
electrical inspection.
[ ] Power up the motor starter. Check for control voltage at control panel terminals 1TB1-1 and
1TB1-2. _______ Volts.
[ ] Check current to the oil sump heater. ________ Amperes
[ ] As the oil heats up, finish any operations not yet completed in preparation for starting the unit.
C. Chiller startup
1. Make all preliminary checks
[ ] Oil temp, oil level, chilled water flow, chilled water load available, etc.
8
Water Cooled Chillers with FastPak
Commissioning Checklist and
Startup Test Log
CVRC-M-1D