Table of Contents
Advertisement
RSTi-OM User Manual
GFK-3212A
7.4
Editing Parameters - IO-Link Device ISDU Interface -
Port
The IO-Link Device ISDU Interface follows these guidelines:
•
•
If the appropriate IODD files have been loaded, you can use the IO-Link Device-Port table to
determine the index numbers and acceptable values for each parameter.
Note: An IODD file may not contain every IO-Link device setting depending on the IO-Link device
manufacturer. If you need to change a parameter that is not displayed in the IO-Link Device-Port
table, you can refer to the IO-Link Device Operators Manual.
If an IODD file has not been loaded for an IO-Link device, you can use the IO-Link Device Operator's
Manual to determine the ISDU indexes.
7.4.1
Overview
The following provides some basic information about the command usage and responses when using
the ISDU Interface.
1. You must enter the decimal value for the ISDU Block Index and ISDU Sub-index.
2. The GET button retrieves the parameter value in hex from the IO-Link device. You may want
Figure 57: Response from GET
3. The SET button sends the value to the IO-Link device.
Figure 58: SET button sends the value to the IO-Link Device
Configuring IO-Link Devices
If necessary, convert hexadecimal ISDU index numbers to decimal, you must enter the
decimal value for the ISDU Block Index and ISDU Sub-index numbers.
You must enter the hexadecimal value for the IO-Link device parameters.
to retrieve values to determine the data length.
Section 7
Jun 2021
72
Advertisement
Table of Contents
