Operation
4.11 Setting the sewing foot
Information
The sewing foot is supposed to hold down the sewing material without
clamping it.
If set too low, the sewing foot can cause ruffling on the seam.
If set too high, the sewing foot can cause skip stitches.
4.11.1 Setting the sewing foot height
Fig. 26: Setting the sewing foot height
(1) - Sewing foot
(2) - Plastic
(3) - Transfer plate
Information
The sewing foot (1) is supposed to lightly touch the plastic (2) of the trans-
fer plate (3) when at the bottom dead center.
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
CAUTION
Risk of injury from sharp parts!
Puncture.
Machine is at a safe stop.
①
②
③
④
(4) - Adjusting wheel
(5) - Adjusting wheel
⑤
39