Siemens SINAMICS G120D Operating Instructions Manual page 54

Installation
4.2 Electrical Installation
Cable, connectors and tools specifications
The detailed specifications for the cables, connectors and tools required to manufacture the
necessary cables for the SINAMICS G120D are listed in the following tables. The connections that
are detailed in this section relate to the physical connections that exist on the converter.
Information for the preparation and construction of the individual connectors have separate
detailed instructions delivered with the ordered parts, direct from the manufacturers. Use 75 °C
copper wire only.
Note
NFPA compatibility
The converter is intended only for installation on industrial machines in accordance with the
"Electrical Standard for Industrial Machinery" (NFPA79). The converter it not designed for
installation in accordance with the "National Electrical Code" (NFPA70).
Table 4-10
Crimp tool (Q8/0 and Q4/2)
Removal tool (Q8/0)
Removal tool (Q4/2)
No special tools are required for the Control Unit connectors
Table 4-11
Connector
24 V DC power supply In (7/8")
24 V DC power supply Out (7/8")
PROFIBUS In (M12)
PROFIBUS Out (M12)
PROFINET Port 1 and Port 2 (M12)
Digital input and output
Encoder (M12), analog input (M12)
You find information about KnorrTec in the internet:
partner)
Table 4-12
Connector
24 V DC power supply
RJ45 PROFINET
52
Tools
Control unit connectors
Knorrtec (http://www.knorrtec.de/index.php/en/company-profile/siemens-solution-
Push-Pull variant PROFINET and 24 V DC connectors
Article number
3RK1902-0AH00
3RK1902-0AJ00
Harting part number 0999-000-0305
Article number
Straight connector
6GK1905-0FB00
6GK1905-0FA00
6GK1905-0EB00
6GK1905-0EA00
6GK1901-0DB20-6AA0
3RK1902-4BA00-5AA0
Via KnorrTec
Article number
6GK1907-0AB10-6AA0
6GK1901-1BB10-6AA0
Operating Instructions, 10/2020, FW V4.7 SP13, A5E34262100B AH
Right-angle connector
3RK1902-3DA00
3RK1902-3BA00
3RK1902-1DA00
3RK1902-1BA00
3RK1902-2DA00
3RK1902-4DA00-5AA0
Converter with the control units CU240D-2