Siemens SINAMICS G120D Operating Instructions Manual page 111

Parameter
Table 7-2
Number
p0003
p0010
p0124[0...n]
p0791[0...1]
p0970
p0971
p0972
p2040
p2111
p3950
p3981
p3985
p7761
p8402[0...8]
p8805
p8806[0...53]
p8807[0...15]
p8808[0...53]
p8809[0...53]
p8980
p8981
p8982
p8983
p9400
p9484
Table 7-3
Number
p0015
p0100
p0170
p0180
p0300[0...n]
p0304[0...n]
p0305[0...n]
p0505
p0595
p0730
Converter with the control units CU240D-2
Operating Instructions, 10/2020, FW V4.7 SP13, A5E34262100B AH
Parameters that can be changed with active know-how protection
Name
Access level / Acc_level
Drive commissioning parameter filter / Drv comm par_filt
CU detection using LED / CU detect LED
CO: Fieldbus analog outputs / Fieldbus AO
Reset drive parameters / Drive par reset
Save parameters / Sav par
Drive unit reset / Drv_unit reset
Fieldbus interface monitoring time / Fieldbus t_monit
Alarm counter / Alarm counter
Service parameter / Serv par
Acknowledge drive object faults / Ackn DO faults
Master control mode selection / PcCtrl mode select
Write protection / Write protection
RTC daylight saving time setting / RTC DST
Identification and Maintenance 4 Configuration / I&M 4 Config
Identification and Maintenance 1 / I&M 1
Identification and Maintenance 2 / I&M 2
Identification and Maintenance 3 / I&M 3
Identification and Maintenance 4 / I&M 4
EtherNet/IP profile / Eth/IP profile
EtherNet/IP ODVA STOP mode / Eth/IP ODVA STOP
EtherNet/IP ODVA speed scaling / Eth/IP ODVA n scal
EtherNet/IP ODVA torque scaling / Eth/IP ODVA M scal
Safely remove memory card / Mem_card rem
BICO interconnections search signal source / BICO S_src srch
Parameters that can be read with active know-how protection
Name
Macro drive unit / Macro drv unit
IEC/NEMA Standards / IEC/NEMA Standards
Number of Command Data Sets (CDS) / CDS count
Number of Drive Data Sets (DDS) / DDS count
Motor type selection / Mot type sel
Rated motor voltage / Mot U_rated
Rated motor current / Mot I_rated
Selecting the system of units / Unit sys select
Technological unit selection / Tech unit select
BI: CU signal source for terminal DO 0 / CU S_src DO 0
Protecting the converter settings
7.2 Know-how protection
109