Connection To The Telephone Line And Electrical Power Supply - Olivetti OFX 1200 Instruction Manual

CONNECTION TO THE TELEPHONE LINE AND ELECTRICAL POWER SUPPLY

Before connecting the fax machine to the electrical power supply, it must be connected to the telephone
line.
Since the connection of a telephone, fax or answering machine or other device to the telephone line is
regulated by laws that vary from one country to another, the information which follows illustrates a generic
connection (case 1) and a specific connection for Germany and Austria (case 2).
CONNECTION TO THE TELEPHONE LINE (CASE 1)
The connection between the fax machine and telephone line is made using the cable provided. Do not use
other cables, otherwise the fax machine may not work properly.
Fax machine
1.
Insert the "miniature" connector (which is small and transparent) of the telephone line connection
cable into the "LINE" socket on the fax machine. You will hear a click which indicates that it has
been inserted correctly (see the diagram which follows). The fax's connection sockets are situated
on the rear left-hand side of the casing. The TEL1 and TEL2 sockets cannot be used in some
countries.
2.
Insert the plug (which differs from one country to another) at the other end of the cable into the
telephone line wall socket (see the diagram which follows).
IF..
•
the network to which the fax machine is connected has more than one socket connected in
series, the fax machine must be connected to the primary socket.
Handset:
1.
Remove the precut cover, if present, from the connection socket (TEL1) on the fax machine, then
insert the "miniature" connector of the telephone cable into this socket. You will hear a click when it
has been inserted correctly (see the diagram which follows).
Other devices:
1.
Remove the precut cover from the connection socket (TEL2) on the fax machine, then insert the
"miniature" connector of the additional device into this socket (in some countries, this connection
is not allowed).
12
CONNECTION AND INITIAL SET-UP